Can I use Thompson Water Seal to preserve bamboo? Soaking bamboo in sea water for a month is also very effective. For example, Chromium is responsible for fixation, copper is effective against decay fungi and soft rot and the third compound acts against insect and fungus. And, raise it off the ground and separate it from concrete, because concrete wicks moisture. Lots of details, plus it depends on how you’ll use the bamboo structurally. You need cold water, borax/boric acid, a bucket half the size of the pole, and patience. It will work with recently-cut poles and no more than 2 m in length. I'm looking for a non-toxic, non-chemical finish. The key is to remove the moisture, natural starches and sugars without cracking the bamboo. Very fine but may I suggest to give commercial name of chemical items?! Bamboo will grow and spread quickly, but there is no real way to direct it into far corners of the garden. I work with bamboo baskets made with the untreated inner part of bamboo and I have been experiencing mold and borers every so often.I am thinking of treating it with the boric acid/borax solution but since I do not have a big tank to soak all the baskets for a long time, I am planning to simply submerge them for a minute or so in a bucket and then let them dry and absorb the salts. Add red analyn textile dye. 4-5% indoor use (not exposed to weather or ground contact). google_ad_client = "ca-pub-5374172349179330"; Buga, Valle del Cauca, Colombia | +57 316 657-1547 | info@guaduabamboo.com, Copyright © 2007-2021 www.guaduabamboo.com | All Rights Reserved. Thank you very much! 3.3 Low Fire Resistivity. I am fully convinced with the process, I went through all the process and it was good. Good luck. 5. … Do you think that would work?The baskets are to be displayed indoors. Curing bamboo or ageing it for marine use. This treatment is intended to protect materials against fire as well as decay and insect attack. This site uses Akismet to reduce spam. Why can’t you just paint a sealant on the bamboo? The dry poles and splits easily absorb the salt of the sea. The most eco-friendly and effective way to cure bamboo is by mixing boric acid with borax (you can buy this as a pre-mixed solution under the name: Timbor) in a ratio of 1:1.5 with a concentration of 5%. To do this, we, "Horizontally Emerse" the bamboo culms in a 5 % solution which is a fast and reliable method to ensure our projects use the best material possible. YouTube Concentrates which can be diluted with mineral turpentine oil are more economical for industrial use. Joined: Sep 15, 2005 Messages: 1,590 Likes Received: 0 Trophy Points: 0. So it’s easy to buy in either of those preparations. Try it and see. In buffering capacity study shows that treated bamboo was more stable towards alkali. And why this solution? Some soak the bamboo in a stream or river. Slowly add water stirring constantly until BORAX/BORIC ACID and dye are completely dissolvedand no more crystals are at bottom of container. Is it advisable to treat bamboo chemically after heat treatment? Depending upon the carrier solvents, bamboo preservatives are divided into 2 different categories: Non-fixing and fixing type preservatives. Whereas, borax-treated strips had the highest wetting rate where the value is 1°. 4. This may be done with various success rates in the following manner, depending on your geographical area (I.E. Is it possible to treat bamboo by submersing in sea water? Is it good for big structures? Would soaking be enough? //-->. Cut the bamboo pole and within 2-4 hours, place in a bucket with some leaves still on the pole. The purpose of this study was to further investigate the effects of different boric acid and/or borax treatments on the thermal curing behavior of bamboo filaments, now my only concern is how can i test whether the bamboo is treated or not. Boric Acid and Borax: The combination of boric acid and borax is a very effective fungicide and insecticide for bamboo treatment. Chopsticks, cups and so on? After treat bamboo like this can we use it for bamboo reinforcement.? And bamboo preservation is a basic component. Sourabh Phadke YouTube channel Without this soaking method, it cracks, decays and is eaten by molds, termites & insects. . Finishes (such as natural linseed oil) are used to give bamboo a desired look or to protect them from weathering. temperature and relative humidity). If you are cutting bamboo in small amounts, this method is very easy and effective. I want the poles to last at least ten years. I plan to build a pergola cover. Warm some water to dissolve the solution and pour it on the bucket with the poles and the cold water. With the treatments that you have listed, what are the degradation times for bamboo including if it is not treated?